You are here - Homepage > Tanking Systems > PAM Battery Back-Up

PAM BATTERY BACK-UP PUMP SYSTEM

	PAM BATTERY BACK-UP PUMP SYSTEM (top)
	Position the Battery Back-up Pump kit in the desired location.
	Run the flexible suction hose from the pump to the sump and secure approximately 100mm from the base of the sump.
	Connect the outer end of the suction hose to the pump inlet with the jubilee clip provided.
	Connect the float switch (which is attached to the main pump) wire to the connector block inside the back-up pump chamber.
	Solvent weld the discharge pipe to the pump outlet and connect to suitable drainage point: - Drainage Gully, Boss Connector or T-Connector.
	Connect battery terminals and plug-in battery charger to power supply. The battery will begin to charge.
	The battery charge state is indicated by the L.E.D display on the charger. Once the battery is charged, fill the sump chamber to test the system. (See fig 56 photo illustrating pump operation test)

(top)